WME Advanced Closures: verschil tussen versies
Geen bewerkingssamenvatting |
Geen bewerkingssamenvatting |
||
| Regel 6: | Regel 6: | ||
<!--T:1--> | <!--T:1--> | ||
==WME Advanced Closures== | ==WME Advanced Closures== | ||
Waze Map Editor (WME) [[Scripts|script]] | Waze Map Editor (WME) [[Scripts|script]] voor het verwerken van terugkerende en geïmporteerde [[Closures|closures]]. | ||
<!--T:2--> | <!--T:2--> | ||
Versie van 16 apr 2025 14:46
WME Advanced Closures
Waze Map Editor (WME) script voor het verwerken van terugkerende en geïmporteerde closures.
Hoe het script te gebruiken
The dialog panel of advanced closures is opened by clicking the button on the closure tab of a segment. Het dialoog venster bevat twee onderdelen.
Top sectie
1. Range
Datum range die voor de closure(s) toegepast moet worden.
2. Start
De starttijd van de closure in hh:mm
3. Duration
De tijdsduur van de closure. Bovenste veld is voor de dagen, onderste veld is voor de uren.
4. Other properties of the closure
Bottom Sectie
| Repeat
When you want to add the closure a number of times, every day/hour/minute. The amount is limited by the range in the top section. The frequency must be higher than the duration that is entered in the top section. |
|
| Each
When you want to add a closure only on certain weekdays. |
|
| Holidays
Should allow you to load public holidays within the set date range, but this is currently not working. |
|
| Load Settings
Gives you the opportunity to copy the top section from another segment with a closure. If there are multiple closures on a segment, you can select the one you want to copy from the dropdown. |
|
| Preview
The preview shows the closures that will be put on a selected segment when you click apply. It allows you to verify data has been entered correctly and that the closures will appear as intended. An orange exclamation mark icon will appear at the end of each line if it has an issue. You can see what the issue is by hovering over the icon with your cursor. After you click apply, a green “OK” will appear for closures successfully added. |
|
Note that if you add more than a handful of closures, it will take a good few minutes to process this. Meanwhile some closures may show in a single direction only, even when they have been entered as dual direction closures. Please wait and refresh the view to check whether all went well.
Pro-tip: adding a lot of closures to multiple segments is not always working nicely. If at all possible, it’s better to apply multiple closures to one segment at the time.
